OUR CABLE (0026) WILL WORK AS A DIRECT REPLACEMENT,, THE ONLY DIFFERENCE IS THE ELBO IS CHROME INSTEAD OF BLACK.. OR !!! IF YOU ARE TRING FOR A 100% RESTRO THEN OUR NUMBER (CB37) IS EXACTLY THE SAME EXCEPT THE INNER CABLE IS 16MM LONGER, WHICH IF YOU GET ONE OF THE SOLDER ON CABLE ENDS LISTED BELOW ON THIS PAGE, AND SHORTEN THIS CB37 BY 16MM AT THE CARB END (WHICH WONT SHOW)YOU'LL END UP WITH A PERFECT REPLICA OF THE STOCK 82 TO 86 CT110 CABLE. @ *THROTTLE CABLE BLACK FITS (SOME_K5's) CT90K6 TO THE 1979 CT90'S (78_&_79_CT90_READ) (ALL_ST90'S) 17910-102-770 or 17910-128-000 1/22M (0026) (230R) THIS IS THE THROTTLE CABLE FOR THE CT90K6 THRU 1977 AND ALL ST90'S IT WILL WORK ON THE 1978 AND 1979 CT90'S BUT YOU MUST MAKE SURE YOU HAVE SOME FREE PLAY IN THE TWIST THROTTLE PIPE. THERE ARE 3 PLACES THIS ADJUSTMENT AND BE MADE, START OUT WITH THEM ALL A CLOSED AS POSSABLE DO THE THE FOLLOWING: 1. WHEN YOU SCREW THE NEW CABLE INTO THE HANDLEBAR SWITCH CASTING, SCREW IT IN TO WHERE THERE IS JUST BARELY 3 OR 4 THREADS FOR THE LOCK NUT TO GO ON 2. AT THE OTHER END OF THE METAL 90 DEGREE ELBO MAKE THAT AS SHORT AS IT WILL GO 3. ON THE TOP OF THE CARB THERE IS THE BRASS NUT WHERE THE CABLE GOES INTO THE CARB , UNDER THE RUBBER BOOT, MAKE THAT AS SHORT AS IT WILL GO 4 DOING THESE THREE THINGS YOU SHOULD HAVE TOO MUCH FREE PLAY, THEN YOU CAN ADJUST IT BACK OUT AT THE TOP ADJUSTER NUT. 230R NO LONGER AVAILABLE FROM DRATV @ Z86'd**THROTTLE_CABLE CT110_1980_&_81 (CB37) 17910-459-670 (231A) exed sorry discontinuedTHIS IS A CT110 THROTTLE CABLE THAT WILL FIT 1980 THRU 1981. overall inner cable length 37 3/4" overall outter cable length (counting elbo) 32 1/2" 231A @ SOLDER_ON_INNER THROTTLE_CABLE 1/20W (END) (359E)FOR SHORTINING INNER CABLE LENGTHS OR SHORTING THE OUTER CABLE TOO END (359E)