SHIFT PEDAL YOU MUST REMOVE THE THGHTENING BOLT BEFORE SLIDING ONTO THE SHIFT SHAFT SPLINES,, THEN SLIDE THE BOLT BACK IN WITH THE GROOVE IN THE SHAFT ALIGNED UP WITH THE BOLT HOLE IN THE PEDAL. THIS IS THE STANDARD SHIFT LEVER / PEDAL THAT THE FACTORY SENDS, SO IF YOU WANT HEAL TOE YOU HAVE IT BUT MOST OF THE TIME PEOPLE CUT THE HEAL END OFF AT THE ANGLE SHOWN IN THE PICK TO THE UPPER LEFT. TRY TO KEEP AS MUCH OF THE WELD AS YOU CAN, I SMOOTH IT OUT WITH AN ANGLE GRINDER. IF YOU HAVE A BIT OF SILVER PAINT IT WOULD NOT HURT TO SHOOT THE PARTS OF THE FRESH CUT/GRIND.