   THIS IS AN OEM HONDA FORK BOOT, JUST NOT REALLY FOR THE BIG RED'S.THEY ARE MADE OUT OF THE GOOD RUBBER THAT LASTS FOR YEARS NOT MONTHS!!! AND THIN WIDTH SO THE TIRES DON'T RUB HOLES IN THEM. SO IF YOU WANT TO SAVE $14 EACH OVER THE PRICE OF THE STOCK BOOTS AND YOUR FORKS ARE ON THE IFFY SIDE OF LIFE (AKA-RUST) THEN MAYBE THESE ARE FOR YOU. THIS IS FOR TRIKES THAT HAVE SOME WIGGLE IN THE FRONT, AND OR TOO FAR GONE TO SPEND $100'S ON THE PARTS TO REBUILD THE FRONT END CORRECTLY,, WHICH SOME ARE DISCONTINUED SOME HELPFUL TIPS ARE 1 REMOVE THE FRONT WHEEL 2 REMOVE BOLT #23 3 NEVER REMOVE NUT #18 !!! 4 RUBBER OR BRASS MALLET OUT THE LOWER FORK LEGS 5 KEEP THE LEGS UPRIGHT TILL YOU GET TO THE GARBAGE CAN 6 DRAIN THE OLD RUSTY WATER INTO THE GOOD BOTTOMED GARBAGE CAN 7 YOU WILL HAVE TO CUT OFF OR REMOVE THE #13 SWIPERS 8 USE THE WATER HOSE TO WASH OUT THE MUD IN THE LOWER LEGS THEN LET DRY GOOD. 9 GET A CAN OF SPRAY WHITE LITHIUM GREASE AND SPRAY DOWN IN THE LOWER LEG, PLENTY 10 11 12 REUSE OR REPLACE #17 BAND, I USED A NYLON WIRE TIE (SHOULD BE BLACK) |