Click to enlarge

@ CYLINDER PAINT_MASKING_KIT CT90_ATC90_ST90 CL90_S90_SL90_CM91 (D7016)

THE MASKS YOU GET WILL HAVE #'S PRINTED ON THEM LIKE THE TOP PICTURE SHOWS.

SCROLL DOWN ON THIS PAGE TO SEE INSTRUCTIONS FOR INSTALLING.

D7016

Click to enlargeSTART WITH YOUR CYLINDER BORE HONED AND READY TO BOLT ON

THEN MAKE SURE ALL NONPAINTED SERFACES ARE CLEAN AND OIL FREE

Click to enlargeSTEP 1 THIS WILL HAVE TO STRETCH A BIT AROUND

THE CYLINDER SKIRT BOTTOM,, TAKE YOUR TIME CENTER THE BIG END OVER CAM CHAIN OPENING

Click to enlargeSTEP 2 CENTER #2 MASK ON THE SKIRT BOTTOM

WRINKLES ARE NORMAL #3 MASK WILL COVER THEM

Click to enlargeSTEP 3 USE MASK #3 LIKE A PEICE OF TAPE

KEEP IT JUST TOUCHING TO THE #1 MASK

Click to enlargeSTEP 4 PUT MASK #4 OVER THE ROLLER BOLT HOLE
Click to enlargeSTEP 5 PUT MASK #5 OVER THE SHOWN STUD HOLE

THIS IS WHERE OIL FLOWS UP TO THE HEAD

Click to enlargeSTEP 6 CENTER MASK #6 OVER THE TOP OF THE BORE

SO IT COVERS THE HEAD GASKET SERFACE

Click to enlargeSTEP 7 PROBABLY THE MOST TRICKY TO CENTER OF ALL

THATS WHY THER ARE 2 OF THIS #7 MASK (:

Click to enlargeSTEP 7 CENTER MASK #7 OVER THE LARGE CHAIN OPENING

I USED THE BACK OF A BIC THEN MY FINGER

Click to enlargeFINISHED LOOK AT THE TOP OF CYLINDER
Click to enlargeYOU CAN TAKE THE EXTRA VINYL AND GENTLY FOLD IT UP

LIKE IN THE NEXT PICTURE BELOW

Click to enlargeEXTRA VINYL IS FOLDED UP TO ALLOW SPRAY ONTO FIN ENDS
Click to enlargeNO NEED TO FOLD EXTRA VINYL ON THIS END
Click to enlargeTOP OF NEWLY PAINTED CYLINDER
Click to enlargeBOTTOM OF NEWLY PAINTED CYLINDER