Click to enlarge

..AFTERMARKET IGNITION_SWITCH (REPLACES_2_WIRE) CT90K0'S <P> W/FRAME#_HIGHER THAN_122550 (2_POSITION_OFF_ON) (ALSO_ENGINE_SWAP) 9/14C (314X)

WHEN USING ON STOCK CT90K0'S THAT HAVE FRAME NUMBER'S

HIGHER THAN 122550 SIMPLY PLUG THE BLACK W/WHITE STRIPED WIRE

INTO THE GREEN WIRE (BOTH ON NEW SWITCH) TO SEAL THEM OFF

AS THEY ARE NOT USED.

SEE THE LOWER PICTURE AS IT COMPARES THIS SWITCH WITH AN ORIGINAL SWITCH.

THEN PLUG THE BLACK WIRE IN WHERE THE BLUE WIRE WAS AND

THE RED WHERE THE RED WIRE WAS, AND BINGO DONE.

P.S. DON'T OVER TIGHTEN THE BOLTS/SCREWS THAT HOLD THE NEW

SWITCH TO THE FRAME AS THIS IS PLASTIC AND THE OLD WAS STEEL

-------------------------------------------------------

IF YOUR INSTALLING A CLONE ENGINE INTO A K0 THIS SWITCH IS PERFECT AS IT HAS 2 CIRCUITS ONE TO TURN THE POWER ON TO EVERYTHING AND ONE TO KILL THE CDI UNIT TO SHUT OFF THE ENGINE

314X$19.97