THIS WILL NOT WORK WITH ELECTRIC START CLONE ENGINES AND YOU MUST USE YOUR OLD PULLSTART AND LEFT SIDE CASE SOME OF THE ENGINES THIS CAN WORK ON ARE THE LIFAN, ZONGSHEN, AND JIALING 50CC 70CC 90CC 100CC 110CC 120CC 138CC 140CC KICK START ONLY ENGINES (NOTE!!) SOME 110CC LIFANS NEED TWO SPACER PLATES, THIS KIT ONLY HAS ONE, SO YOU MAY NEED TO GET ANOTHER AT THE BOTTOM ON THIS PAGE. THERE WILL BE NO RESTOCK FEE IF YOU SEND JUST ONE PLATE BACK. NOW ALSO FITS OUR LIFAN 150CC WITH CHARGING ALTENATOR ADD_YOUR_ATC70'S PULLSTART TO_A_NEW_LIFAN KICK_ONLY_ENGINE (KIT) BC1001/FW&CAGE/99E/3EA6X25PH$114.99 REMOVE THE NEW FLYWHEEL COVER FROM NEW ENGINE PULL THE FLYWHEEL OFF WITH SAME PULLER AS ANY ATC70 TAKES,, ALSO ON THIS PIC SEE THE PROBLEM CAUSING CDI PICK UP UNIT REINSTALL THE NEW CAGE/FLYWHEEL THIS PICTURE SHOWS WHERE ALUMINUM NEEDS TO BE REMOVED WITH DREMMEL OR 4" DISK GRINDER, SO THE CASE WILL CLEAR THE NEW CDI PICKUP UNIT THIS PICTURE SHOWS WHERE TO ADD SOME POP OR BEER CAN FLAT ALUMINUM AND SEALER , TO SEAL OUT DIRT AND WATER FROM FLYWHEEL CAVITY ADD THE SPACER PLATE,, GASKETS IF YOU WANT THEM AND YOUR OLD PULLSTART, AND BOLT BACK ON NEW ENGINE THESE ARE NEW FLYWHEELS AND CAGES FOR THE ATC70 PULL START, THEY ARE MACHINED FLAT,, THEN DRILLED AND THE HOLES FILLED WITH WELD IN 2 PLACES (15) PULLY BOLTS TO FLYWHEEL FOR STARTER ATC70'S (99B) XED 099B *GASKET_PULL START_ATC70 8/10A (99E) 99E$3.39 *(1) ATC70 RECOIL_STARTER COMPLETE_ASSY (oem_Honda) 1981_to_1985 (73_to_80_READ) (99F) EXED sorry discontinued 099F 6MM X 20MM PAN HEAD SCREW 337804$0.42 SPACER PLATE ONLY ABOUT 1/4" (BC1001 BC1001$12.95